- Home
- DSLR Rigs
-
Camera Support
- Sony PMW-F5 and PMW-F55
- Sony PMW-F3 / FS-100 Accessories
- Sony NEX FS-700
- New Products
- RED Accessories
- Canon EOS C100, C300, C500
- Blackmagic Accessories
- Camera Base Assemblies
- Camera Base Components
- 60mm Rail Blocks
- Blocks
- Rods and Rod Accessories
- Handles and Accessories
- Shoulder and Chest Pads
- Lens Supports
- Counterweights, Battery Mounting and Wireless
- Hardware
- Grip Gear
- Component Groups
- Galleries
- About Us
- Contact Us
-
Grip Gear
For years grips have asked why Berkey System components aren't manufactured in the same size as grip gear and to them we would say "Grip gear is made in the wrong size!" As you might have guessed, that did not go over very well. In a effort to make friends with the grips on any crew, Berkey System is now offering a number of components based on the 5/8th's inch standard for grip gear. Berkey System components are made from 6061 aluminum and are black anodized for durability. All Berkey System products are made in the USA and are covered by our Lifetime Warranty. See Terms and Conditions for details.
Suction Base, 3 inch
The 3 inch diameter suction base creates a strong vacuum with just a few strokes on the built-in pump. A red ring indicator on the pump button lets you know when you have insufficient vacuum. Use the lift tabs to break the suction. Comes with the Berkey System mounting plate on top that is drilled and tapped for two 1/4-20 fasteners and cup protector. Mount anything on any flat or slightly curved non-porous smooth surface. Fun! Maximum temp. is 120 F. Lifting capacity is 15 pounds.
Suction Base, 7 inch
The 7 inch diameter suction base creates a strong vacuum with just a few strokes on the built-in pump. A red ring indicator on the pump button lets you know when you have insufficient vacuum. Use the lift tabs to break the suction. Comes drilled and tapped for two 1/4-20 fasteners and cup protector. Mount anything on any flat or slightly curved non-porous smooth surface. Fun! Maximum temp. is 120° F. Lifting capacity is 70 pounds.
15mm to 5/8″ Grip Gear Interface Rod
Need to mount you camera in the strangest places and have it work with existing grip gear? Now you can. Just insert the 15 mm end into any 15 mm series block and make new friends with all the grips. Also available in 500 and 750/19mm series.
1/2″ to 5/8″ Grip Gear Interface Rod
We've all been there, you're on the set with the coolest damn rig that you've ever built and some grip comes up to you and says "How come this stuff isn't made in 5/8th's inch so it will work with my C-stands?". Now it can work with any standard grip gear to or from your rig. Just attach this rod to any 500 series block and make new friends with all the grips.
19mm to 5/8″ Grip Gear Interface Rod
We've all been there; you're on the set with the coolest rig that you've ever built and some grip comes up to you and says "How come this stuff isn't made in 5/8th's inch so it will work with my C-stands?". Now it can work with any standard grip gear to or from your rig. Just attach this rod to any 750/19mm series block and make new friends with all the grips. Available in 15 mm, 500 and 750/19mm Series.